|
|
|
Use this tool to learn about websites, specifically the one you just entered.
If you find some aspect of it inappropriate it is not our fault.
If you are the owner of this website: yes we are a real search engine, we do have a real web crawler called FyberSpider and you can block it if you feel the urge.
We are in the process of updating this tool. Until we are done just use our search results to check the inclusion status of your site.
Submit your site to major search engines within 48 hours.
Find out if your site has been cataloged by top search engines for only $8.99.
Below you will see site info taken directly from the URL you entered in real time. This is also known as our URL Breakdown tool and can be used independently of our site info tool.
Garrett Metal Detector
This is just a sample of the content found on this website. Please visit the website to read the entire page.
"A&S Company Order Line (408)248-1233 We Ship Nationwide
OPERATING INSTRUCTIONS:
MASTER HUNTER CX
MASTER HUNTER CX PLUS
ASSEMBLY INSTRUCTIONS:
1. Compress the button ends of the spring clip and insert them, button end first, into the lower stem of the detector so that the button ends pop out of the holes. The spring clip has been installed in the upper stem at the factory. This will enable the stem assembly to be attached to the electronic housing and the over all length of the detector adjusted for a comfortable operating length.
2. Attach the lower stem to the searchcoil by inserting the two rubber washers into the stem and slipping the searchcoil onto the stem. Insert the threaded bolt through the holes and hand-tighten the two knobs.
3. Install the upper stem to the lower and then this assembly to the detector housing by depressing the buttons and coupling the stem to the housing. Adjust for the most comfortable operating length.
4. Wrap the searchcoil cable snugly about the stem with the first turn of the cable over the stem.
5. Insert the cable connector into the connector on the detector housing and hand-tighten securely.
STARTER PHASE:
GETTING STARTED:
SETTINGS: Make certain the two knobs on the side control panel are dialed to the Initial Setting arrows . Touch no other controls.
OPERATION:
1. Grasp the handle of the d
1000
etector making certain there is no metal nearby, and lower the searchcoil to a level of about one foot above the ground.
2. Press the Power touchpad.
3. After you hear the beep, the detector is operating in the Discriminate Mode.
Note: The optimum audio threshold level is a faint audio sound which has been preset at the factory. If AudioThreshold adjustment is necessary, Press and Hold the All Metal touchpad and press the (+) or (-) touchpads to achieve the preferred threshold sound level.
If the threshold has been adjusted, press the DISCriminate touchp"
....
read entire page
|
Links to Pages on the Same Domain Name
|
|
